I'm sorry if this starts to read like war and peace but I am really stumped.
I have all new sensors.
I have checked that I have a good earth through out the engine bay.
My OBD says that I have a fault with my Engine Coolant sensor (Replaced). Fault with MAP sensor (Replaced) O2 sensors fault (Replaced).
I have checked that I have the signal on all the wiring.
Checked the Ohms where needed.
All reads good.
The really daft thing is when I Have Live Data reading I am getting info read outs for all the above sensors.
So I really don't understand what's going on.
I should also point out that I have replaced the head gasket and put a new coil on.
But the car starts runs for 20 seconds then goes into what I think is limp home mode and engine revs go to 1750 revs and stays there, if I put my foot on the throttle I can get another 500 revs out of it.
Help please !!!
I have all new sensors.
I have checked that I have a good earth through out the engine bay.
My OBD says that I have a fault with my Engine Coolant sensor (Replaced). Fault with MAP sensor (Replaced) O2 sensors fault (Replaced).
I have checked that I have the signal on all the wiring.
Checked the Ohms where needed.
All reads good.
The really daft thing is when I Have Live Data reading I am getting info read outs for all the above sensors.
So I really don't understand what's going on.
I should also point out that I have replaced the head gasket and put a new coil on.
But the car starts runs for 20 seconds then goes into what I think is limp home mode and engine revs go to 1750 revs and stays there, if I put my foot on the throttle I can get another 500 revs out of it.
Help please !!!
Clio nightmare goes on
Aucun commentaire:
Enregistrer un commentaire